• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

peugeot key programming 308 Key Fob Replacement

Peugeot's 308 might be slightly old but it's appealing. It's not the most luxurious car in its class and a Ford Focus or Volkswagen Golf will help you stay away from sloping surfaces - but it's a relaxing and a civilized drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will help whether the problem is persistent or intermittent.

Water Damage

If you accidentally drop your key fob into an eddy, or it is wet while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. The best way to stop this from happening is to keep it in a dry container when you're outdoors or performing things where the fob might be exposed to a lot of water.

You'll also need to make sure that the fob is dry prior to opening it and reusing it. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid) It's another sign that it has been submerged.

A circuit board that is wet could cause the battery's charge to drop its charge or even explode. If you can get the 308 keyfob from the water, turn the button side up and shake as much water as you can prior to opening the casing. Once you have opened it, take out the battery and clean the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell, receiver module problems, signal interference or a defective chip. If none of the above are the issue, you can reset the system by disconnecting 12 volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start feature that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to getting in. This feature is extremely useful particularly during the winter's cold and chilly months. However, sometimes the remote start system ceases working due to a variety of reasons, like a dead coin battery.

The coin-shaped battery contained inside the key fob will last between two and four months, depending on how often it is utilized, the place it was purchased and how it is used. The date of use is usually written on the package or marked in the manual.

If the key fob has stopped working after exposure to water that is clean then you must take the battery off, clean the chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. In case of exposure to salty or soapy water, the chip may be fried and you will require replacing the key fob in total.

If you're not sure that the battery is not working properly You can test its voltage using a multimeter that is set to the car's voltage range, and connect it to the minus and plus terminals. If the voltage is lower than 12-13 volts, then it is time to replace the battery. Alternatively, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a couple of minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should begin to run after this.

Faulty Receiver Module

If you don't see "Key Detected" you might find that your receiver module is defective. It's the component which sends out the signal when your key fob is activated. It also acts as an alarm that stops the vehicle from starting without the correct key.

This could be due to a range of causes including water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip on the inside will be damaged. In this instance, you'll need to take the unit apart and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once it's dry you can put the battery back into the battery and try again.

If the problem persists it is a good idea to see an area peugeot 107 key expert or locksmith. They'll employ a diagnostic tool assist in identifying the problem and repair it for you.

The loss of your Peugeot car keys could be an extremely stressful experience. However, a qualified auto locksmith can solve the issue in only a few minutes. They can cut a brand new key and programme it to your vehicle, ensuring you're back on the road again in the shortest amount of time. Click here to find a locksmith in your area.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob is an vital component of the remote control system. If it is damaged, your car may not start or get a message saying "anti-theft active". In this situation the only option is to replace the key. Luckily, professional auto locksmiths can offer the service in the shortest time.

The chip inside your Peugeot 308 key fob can become faulty due to sweat, water damage dirt, or other reasons. If your Peugeot 308 key fob has been exposed to soapy water, you must clean it immediately. You can use a paper towel and isopropyl ethanol to clean the electronic component. Then, you need to let the battery completely dry.

Radio interference can cause the key fob to stop functioning. This could be due to other devices operate on the same frequency as your peugeot keys keyfob. It could also be caused by weather conditions or objects around the vehicle. If you experience this problem it is recommended to visit a peugeot 3008 key fob replacement dealership.

The Peugeot 207/308 Key Fob is fragile and requires special care. It is important not to drop or throw the key fob. If you lose something, try to locate it as soon as you are able to. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Remove the negative cable before the positive.